so im guessing i should wait for the motordyne over the skunk2. Or should i just get a y pipe with the headers im ordering instead?

 

so, b/c we get close to 100 degrees for about 3 months out of the summer and it never really gets that cold, I should get the Iso thermal, right??

 

I found the motordyne spacer on another site thats not on back order but it only comes with the iso and cost 240. It gives u a note saying that it is recomended that u purchase NOTE: Extra upper plenum gaskets are recomended, (a total of two). One upper plenum gasket will need to have the center cut out, to match the spacer. Please select below for extra gaskets.
which is an additional 25. Other sites never mentioned this. Any ideas?

 

I didnt need any extra gaskets. The kit came with one and there was nothing wrong with the gasket that was already in the plenum. I didnt have to cut them either.

 

Go here,

http://www.motordyneengineering.com/350z.asp