HKS Exhaust
#22
Registered User
iTrader: (12)
Somebody mentioned using a cold weld? I wonder if JB Cold Weld would work? But if it was me, I'd just take it to an exhaust shop and have it welded up the old fashioned way... And while you're under there, might as well replace the flex joints too... If they can, make sure they use SS tig, so the weld itself is stainless.
Last edited by gothchick; 11-05-2007 at 07:50 AM.
#23
Registered User
Thread Starter
Join Date: Jul 2007
Location: Gilbertsville, PA
Posts: 260
Likes: 0
Received 0 Likes
on
0 Posts
Good news, I fixed the major leak... the flex pipes are crap, both sides leak out, can tell cause the steam comes out of them from inside the exhaust when it starts up... but the major hole was fixed with this stuff called ThermoSteel... good up till 2400degrees, and only gets stronger with heat. And heck yes turbo is needed! I am gonna get a widebody kit just to have wheels wide enough on here to handle it without them pokin out.
#25
Registered User
Thread Starter
Join Date: Jul 2007
Location: Gilbertsville, PA
Posts: 260
Likes: 0
Received 0 Likes
on
0 Posts
nothin says lovin like some 14 inch wide rear wheels and a nice set of 305 or bigger tires on a sweet body kit like the BRS Autodesign's number 2 kit... they got that on their shops yellow Z and it looks so porsche / high end car lookin.
#26
Registered User
iTrader: (2)
Join Date: Aug 2006
Location: SW Florida
Posts: 2,690
Likes: 0
Received 0 Likes
on
0 Posts
Does anyone know the length of the flex pipe? I need to order some, but I don't feel like jacking up the z to measure the length. Since I lowered it, I hate the extra effort it takes to get under the z. If somebody gets under the hks or xo2, measure theirs and let me know. Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM
ars88
Zs & Gs For Sale
18
04-04-2016 07:52 AM