I don't have any PIC’s to post yet. I installed my Injen Intake as a short ram set up. My question is about the piece of the intake that is after the MAS air sensor that the hose attaches too. Because of the hose attachment being on this piece I cannot push the air filter far enough back to keep it from hitting against the front of the engine bay? What am I doing wrong? On all of the pictures I have seen of peoples Z’s with the Injen Intake, even when the CAI tube is attached, it is pushed back all the way. I don't get it...?

And the Injen exhaust sound great, it is soooo deep sounds like an exotic 12 cylinder. If you are cursing along in 6th gear at 60ish and floor it you can really hear how deep this thing sounds. I am really glad I went with the Injen SES exhaust over the Borla. I was waiting for the Greddy to come out but I couldn't wait anymore.

In the picture below the polished piece that the air filter is attached to is what I am referring to. Mine has an additional piece coming out of the side of it for the vacuum hose to attach to and because of it my air filter will not fit all the way back unless I cut out a small half circle of the rubber on the filter.