I purchased the JIC Single SUS 76.3mm piping for my powerlabs ST Z. Is this going to be deafeningly loud? I am worried it might be too loud and get tickets all the time. Do you think it will be raspy with the turbo also?

 

I think you'll be fine.

 

i ran it with no resonator.... it really makes not much different with the turbo, its going to sound BAD ***

 

I emailed JIC about it, they want to vids when it goes on

I was going to go partial Ti or full Ti....but i had to cut costs somewhere. I am just loosing some bragging rights saying it was some cool ultralight material...negligible performance difference except from the heat dissipation properties.

This should be my final step with the boost controller as well as my 6 and <=9 psi maps. hopefully we can get all the kinks worked out...smells like there is a leak in the exhaust under load since I can smell it in the car clear as day and it makes my clothes reek

 

THE ST will be fine... not a whole lot gained with the Full ti other than weight savings, but then again you are pushing over 390whp

 

I bought SUS....full stainless, no Ti in the pipe or muffler

 

Same Difference. Jorge (IIQuicksilver) and Darren (INTENSEPOWER) both had JIC Ti Singles, and it is by far, IMO, the best sounding exhaust with a turbo.

 

Think there is a sound difference between the SUS and Ti? both are type one...just stainless vs. Ti material difference

 

Titanium does resonate at a different frequency then stainless stell, but you wouldn't be able to tell unless you had and F/I Z with a full Ti right next to yours.