Notices
Intake Exhaust Moving all that air in and out efficiently

Help Anyone? =/

Thread Tools
 
Search this Thread
 
Old Feb 1, 2013 | 07:27 PM
  #1  
RedLine_ZR's Avatar
RedLine_ZR
Thread Starter
Registered User
iTrader: (2)
 
Joined: Oct 2012
Posts: 323
Likes: 7
From: Puerto Rico
Default Help Anyone? =/

Ok so yesterday I installed my Jwt pop charger.. I disconnected the battery did the change and connected the battery back up.. This morning it started up fine and went to get a haircut (~15min drive) after I was done I noticed the car started and almost turned off... Rpms went low but came back up to normal.. When I got home I turned it off and back on but it turned off by itself.. I then tried turning it on the and gave it a little gas and it stayed normal.. Any help or ideas as to how to fix the problem?

04 roadster stock besides the Jwt pop charger now


**cold starts its fine just when I start while hot it will do this

Last edited by RedLine_ZR; Feb 1, 2013 at 07:59 PM.
Reply
Old Feb 1, 2013 | 07:35 PM
  #2  
Bmurray350z's Avatar
Bmurray350z
New Member
10 Year Member
iTrader: (34)
 
Joined: May 2011
Posts: 8,075
Likes: 92
From: Burlington, NC
Default

make sure the hose that connects to the back of the intake pipe is all the way one. check the maf also.
Reply
Old Feb 1, 2013 | 07:46 PM
  #3  
RedLine_ZR's Avatar
RedLine_ZR
Thread Starter
Registered User
iTrader: (2)
 
Joined: Oct 2012
Posts: 323
Likes: 7
From: Puerto Rico
Default

I checked it earlier to see if everything was tight seemed fine.. Might double check again in the am but abt checking the MAF. Do you mean check that it's plugged in right which it is.. If not then what else?
Reply
Old Feb 1, 2013 | 08:21 PM
  #4  
freddys 350z's Avatar
freddys 350z
Registered User
 
Joined: May 2011
Posts: 774
Likes: 2
From: schertz, tx
Default

the small hose that connects to the bottom side of the intake pipe.
Reply
Old Feb 1, 2013 | 08:21 PM
  #5  
myork's Avatar
myork
New Member
iTrader: (5)
 
Joined: Mar 2009
Posts: 541
Likes: 9
From: NJ
Default

That is normal as the ECU is learning to adjust to the extra air. Give it a few days and it will stop.
Reply
Old Feb 1, 2013 | 09:59 PM
  #6  
amr_electron's Avatar
amr_electron
Registered User
iTrader: (8)
 
Joined: Nov 2009
Posts: 337
Likes: 14
From: On Earth
Default

I remember mine did the same thing after installing an Injen intake, Doing a reset took care of the problem.

Reset procedure,
Reply
Old Feb 1, 2013 | 10:03 PM
  #7  
Z_on_TE37's's Avatar
Z_on_TE37's
New Member
iTrader: (3)
 
Joined: May 2012
Posts: 436
Likes: 0
From: Ohio
Default

Just google official ecu reset for 350z. Follow all 3 procedures, then it'll run perfect.
Reply




All times are GMT -8. The time now is 07:38 AM.