I just replaced my window motor successfully, but now the window seems to roll down too far and it ends up getting stuck at the bottom. My widow did this before I installed the new motor as well, so I know the motor isn't the problem. I was doing the whole window reset thing, and thats when it got stuck at the bottom. Is there any way I can adjust the regulator so the window doesn't go down as far?

I know this thread isn't in the right section, but I figured more people would see it this way, lol.

Thanks guy

 

Sounds like a malfuntion of the Limiter Switch

 

I've had the same issue many times over 3 years. Nissan just keeps resetting the limiter switch - won't replace the motor as tell me it's not broken. Can usually get the window up by holding on the "raise" button firmly even a few seconds after window goes up, then close door. If passenger side, must be done from driver's side after door is closed. Quite a pain here in the rainy/snowy Seattle!