Guys, have a problem with the power steering pulley, how can I get it of ?? the bolt sits where it sits and I'm about to give up. It is counter clockwise to take it of right ??

Thanks Micael

 

If your sitting in front of the car looking at the engine, it should go counter-clockwise... left loosey, righty tighty...

You are talking the pulley not the belt tensioner at the bottom right? You need to losen the drive pulley before adjusting the belt tension.

 

Thanks, well I was able to look at a pic at Courtesyparts and it seems like the pulley should be pulled straight out ?? so I better get some new tools and try to pull it, just have to get this car on the road as my 300zx kinda died on my today Looks like a total engine build there as well, so now I have 4 cars to build never ends I guess

 

Well for anyone that wonders how to get the pulley of I will post some pic's and steps on how to do it, but you have to take the pump of and open the back of it to get the pulley and attached axel out.

Micael

 

so why were u pulling this apart was the bearing in the pump making noise?