Need help, car wont crank, no codes,
03 350Z daily driver N/A
130K miles
- At the race track and car shutsoff while driving, (PDX event)
- tried to restart but wont even crank, just a single click.
- No error codes for crank and camshaft sensors.
- battery has good charge
- radio and all lights work so i assume altenator good.
- ground cable on battery had light corrosion, cleaned but same problem.
- removed battery for 36hrs to reset ECU, no change.
- fuel pump turns on when i turn the key.
PLEASE I NEDD HELP ASAP BEFORE TOWING TO DEALER.
THANKS
130K miles
- At the race track and car shutsoff while driving, (PDX event)
- tried to restart but wont even crank, just a single click.
- No error codes for crank and camshaft sensors.
- battery has good charge
- radio and all lights work so i assume altenator good.
- ground cable on battery had light corrosion, cleaned but same problem.
- removed battery for 36hrs to reset ECU, no change.
- fuel pump turns on when i turn the key.
PLEASE I NEDD HELP ASAP BEFORE TOWING TO DEALER.
THANKS
Joined: May 2002
Posts: 8,624
Likes: 1,393
From: Aurora, Colorado
It's even money your problem is electrical in nature. I usually try to rule out the lowest link in that chain. That's why I asked how old your battery is. You need at least 12.5 volts DC to operate.
Recheck your ground and positive cables before you take it to the dealer. Let us know what happened.
Recheck your ground and positive cables before you take it to the dealer. Let us know what happened.
Trending Topics
Yea all had to do was replace my starter.
And I'd recommend getting the factory one. Unless you don't mind the ugly noise the aftermarket ones make when you start it. But i guess you can't beat lifetime warranty..
Thread
Thread Starter
Forum
Replies
Last Post
etkms
Engine & Drivetrain
29
Jun 19, 2022 06:30 PM
lolwatbro
Maintenance & Repair
9
Oct 9, 2021 04:58 AM
350Z Project X
Maintenance & Repair
11
Oct 17, 2015 05:16 PM








