P0507 code thrown and high idle
#1
Registered User
Thread Starter
![Default](https://my350z.com/forum/images/icons/icon1.gif)
This is on a 2004 with very few mods - Stillen air cleaner, lightweight flywheel and Wolf clutch.
Back story - the car was occasionally puking (0 RPM) if I would be hammering it and then got out of the gas. Also had begun idling pretty rough.
I cleaned the Mass Air Flow Sensor with MAF cleaner and the throttle body with carb cleaner.
The idle seemed to stabilize and it hasn't puked on me yet.
However - the idle has now gone high (1200) and doesn't seem to come down as quick when you get out of the gas and clutch in.
CEL is on and throwing a P0507 (P0507 Idle Speed Control System )
I'm guessing I need a new MAF sensor but wanted to see if anyone else had seen this before?
Thanks in advance for any advice.
Back story - the car was occasionally puking (0 RPM) if I would be hammering it and then got out of the gas. Also had begun idling pretty rough.
I cleaned the Mass Air Flow Sensor with MAF cleaner and the throttle body with carb cleaner.
The idle seemed to stabilize and it hasn't puked on me yet.
However - the idle has now gone high (1200) and doesn't seem to come down as quick when you get out of the gas and clutch in.
CEL is on and throwing a P0507 (P0507 Idle Speed Control System )
I'm guessing I need a new MAF sensor but wanted to see if anyone else had seen this before?
Thanks in advance for any advice.
#3
Registered User
Thread Starter
![Default](https://my350z.com/forum/images/icons/icon1.gif)
Yes - I definitely opened the TB and used a tooth brush in there.
Why is that a bad thing to do? Not trying to be a jerk - I just don't understand. Doesn't it open with the throttle?
Why is that a bad thing to do? Not trying to be a jerk - I just don't understand. Doesn't it open with the throttle?
#4
New Member
iTrader: (3)
![Default](https://my350z.com/forum/images/icons/icon1.gif)
The 350 is throttle by wire. Electronic control, not linkage. You are probably going to have to go the dealer and have the TB reprogrammed - it has lost it's idle position, although that is not exactly the technical term for it. Lots of threads on this. Search cleaning TB for starters maybe...
Thread
Thread Starter
Forum
Replies
Last Post
liqalu04
Engine & Drivetrain
31
01-02-2022 12:58 PM
Colombo
Forced Induction
35
11-09-2020 10:27 AM