I wanted to change the relative relationship between the gas and brake pedals so that heel-toe would be easier. I made a cardboard pattern and then cut the pedal shape out of sheet metal. Made a few adjustments and bolted it on.

Fortunately most of the holes in the gas pedal go clear through and I didn't have to drill any holes in the pedal...just fastened it with two bolts/nuts...put some deck tape over the pedal so it isn't slippery.

I like the results--not necessarily the appearance. The reach for heel-toe is less and I am more consistent in blipping the gas while down shifting.

Pictures.

 

thanks for the contribution