Quality Japanese parts right there.

 

Yes the track yaris edition

Chris

 

^^ can't wait to see your car finished Chris..

woot.

 

tell me about it

It was obvious the dials were shot so I ripped them off.










I resorted to the most neanderthal of tactics to try and recline.

i like the seats, they are 10/10
but those dials -1223/10

Each dial cost $30.

 

sucks to suck

 

Same here... Wheels need to be decided... Thinking Advans again...

Chris

 

nothing fancy or baller, but

 

Titek Carbon Fiber Intake Duct!

Now where is the sticky or thread on how to cut and install it, especially without damaging my Chameleon paint..

 

 

I used an extra sharp razor knife.

Step by Step:
http://www.*********.com/wiki/index....t_Installation

Template(you have this):
https://my350z.com/forum/showpost.ph...39&postcount=2

Chris

 

The template they gave me doesn't look anything like the duct? Any solutions?

 

it will appear off but if its the one chris linked its correct

 

It feels funny/ sad watching all of joels shyte pop up in this thread.

 

Or you could flip the duct over and trace the outter edge and just cut the duct hole about a .25in smaller than the line and trim till perfect. That's what I did. But templates work

 

Hey what is the first link? lol

 

350z - tech

 

The one they gave me is completely different than the one chris posted you can semi see it in the picture I posted skinny at the bottom then gets fat at the top?

Bober'z thanks man!

 

Yea it is. I tried to keep a majority of the parts on the site.

Yea 350z tech. Post a pic with your template taped to your front bumper. Should be fine.

Atleast you got the pop rivets. My Varis came with the template thats it Don't be scurred its only Plastic or .....

Chris

 

 

Quick question, my TiTek came with 3m double sided tape.. should I use it on the edges of the duct or just rivet it in and call it quits...


This is the back of the TiTek-




This is the template they gave me... clearly doesnt look the same.-