Kinetix SSV Installed
#4
Thread Starter
Registered User
iTrader: (6)
Joined: Aug 2004
Posts: 1,676
Likes: 0
From: Eltmann, Franconia
yeah, only got to go on a 10 minute drive or so, one quick trip up the highway (bit of traffic, so i didn't get it above 100mph (read: into 5th gear)) -- hopefully tomorrow, after I drop my better half off at a garage sale, i can go out and throw it around a bit...
have an autoX the first weekend in july, so that'll be the real test -- hopefully the forged bottom end will be coming together then, so i can cam and header it (tomei 268's and crawfords)
after that? i'm going to try and make a 550rwhp SC (i just like 'em better than turbos, besides I already have a turboed car )
have an autoX the first weekend in july, so that'll be the real test -- hopefully the forged bottom end will be coming together then, so i can cam and header it (tomei 268's and crawfords)
after that? i'm going to try and make a 550rwhp SC (i just like 'em better than turbos, besides I already have a turboed car )
#5
nice i'm contemplating getting this too but i wanna see a dyno to 7k before i buy it....but i did just get a kjr pulley and felt a nice difference....how would you compare gains of the plenum to the gains felt buy a pulley?? i see u/r in your sig so i'm assuming you have u/r pulleys
Thread
Thread Starter
Forum
Replies
Last Post
Extreme Dimensions
Southern California
0
09-24-2015 03:35 PM