hey guys,
I got Toby's Kinetix plenum (picked it up from AAM), and was just wondering if, when new, if the plenum comes with any special bolts and whatnot? I took a look at the install instructions on Kinetix's site, but couldn't really tell. hoping to install it this weekend...
K

 

Is it a V4? If so, then it should have 6 (I think) small 1/4-20 or 1/4-28 screws used to close up the holes on the lower plenum. I'm pulling all this from memory from when I installed mine. I've since sold it...so if anyone wnats to add or make corrections...please do so. I actually found install instructions off of one of the forums and it had pics to go along w/it which really helped.

 

yeh, it's a V4.....damn, do you think those screws can be had a home depot or something? think I might call Kinetix today.

and if you happen to recall that link, that'd be great to check out as well

 

Just realized the screws are going to be metric and so, Home Depot won't have them. I apologize, the sizes I listed are incorrect...I would call Kinetix or email them, their customer service is excellent

 

Here's the page I referenced during my install, it's not a V4, but the install is still very similar. Good luck and have fun w/it
http://www.350zfreak.com/plenum.htm