not really a race from a roll at about 50 ..im pacing him hoping he'll go and he does...i put about half-a-car on him maybe one and kept it there to about 90+ ,too much traffic and he was willing to drive alittle faster in traffic than I...however ill say a Z is much more menuverable than mine so maybe i dont blame him...obviously we live near eachother as basically i followed him around in a big circle back towards my neck of the woods...he turned off i gave a honk on my way by...hey black Z if you read this...i wasnt stalking you,just hoping to catch a light...dont feel bad about not being able to walk on me...im worked...later

 

I have raced 2 3.2 CL Type-s's. Burned em both. One was at a red light on an incline. Once green came,. it looked like he was going backwards it was so slow. but once up to speed he was moving allright. not enough to touch the z though.

 

yea this type R guy has a engine swap..
sounded like u guys had fun

 

not so much a swap ,it's really just a stroked short block ,crank ,rods,pistons, mine did come as a create where i replaced the short block with this one but it's somethin that could be done to the existing engine....ya it was fun...the Z has good mid range....50-120...the only thing is i whished the dude would have gone slower and tried to catch a light...maybe next time...he obviously lives in the area....oh let me tell you aobut this mustang *** hole today...we couldnt get beside eachother at a light but from back to back from a roll we punch it ...move out into open road im on his *** big time and it's a long sweeper....im closing the gap...and this *** slamms on his breaks...i guess he's pissed he couldnt walk on me ...if i catch him around...he'll be handed a nice beatin' ,and not in his car

 

Yeah,

I learned my lesson about running back to back. Not only do you get a face full of debris, but you can't trust the guy in front. I did that in my Camaro, and the guy got on the brakes (with no one in front) and I almost spun the car trying to avoid him. I'll never do that again.

-Bryan

 

yep...im with ya...

 

i havent dyno'd but the guy that built my block dyno'd the same car same setup and it was like 250/225 ...but that wasnt broken in...if i were guessing and ive used some of those models they have for inputing 1/4 and trap and it spits out hp ..i think 260/230 hp /lb.ft.