04DE on JWT C8 cams - Bottom end shopping list req !
#21
New Member
Thread Starter
I have no idea how soo much oil and coolant keeps falling out
Seems to be never ending !
Seems to be never ending !
#22
350Z-holic
iTrader: (13)
I put an inexpensive tarp down and then cardboard to catch everything!
The following users liked this post:
RobPhoboS (11-01-2019)
#23
New Member
Thread Starter
I will update the thread with photos, I've been lazy regarding that
As a mini update, everything was taken down to the machinists back in late Nov.
I bought another (very low mileage) crank, you'll see why in the coming days.
They asked me to take the block back before they did any work to test out the ARP main studs. This was to check if there was any crank-bore distortion (I just used some other used bearings to give me a rough idea with plastiguage). All seemed to check out OK, the measurements seemed right, and pre-plastigauge I checked to see if the crank would turn smoothly, and it did.
The rods were balanced back in Jan, and hopefully by now they've done the block, so I should be able to get on with that part soon enough.
The heads, well I have some options to figure out, as in how far do I want to go (££££).
I'll have a chat with them tomorrow.
Sorry for the lack of photos but they will come !
As a mini update, everything was taken down to the machinists back in late Nov.
I bought another (very low mileage) crank, you'll see why in the coming days.
They asked me to take the block back before they did any work to test out the ARP main studs. This was to check if there was any crank-bore distortion (I just used some other used bearings to give me a rough idea with plastiguage). All seemed to check out OK, the measurements seemed right, and pre-plastigauge I checked to see if the crank would turn smoothly, and it did.
The rods were balanced back in Jan, and hopefully by now they've done the block, so I should be able to get on with that part soon enough.
The heads, well I have some options to figure out, as in how far do I want to go (££££).
I'll have a chat with them tomorrow.
Sorry for the lack of photos but they will come !
Thread
Thread Starter
Forum
Replies
Last Post
plastidipping
Drivetrain
8
07-21-2013 06:59 AM