Hi,

Anyone got a drive by wire setup working with a Jenvey ITB setup?

The Jenvey Actuator has failed twice in my setup.

Also, anyone got an airbox solution that works with the curved horns?

Regards,

Diren

 

Look into someone who can CAD/3dprint. I've made custom horns for a motorcycle which gained 13% horsepower over stock, I'm assuming something could be done with wither a 2-piece box which slips over the rear of the horns and sandwiches on the lip to make a box

or a complete redesign of the horns to taper to run a cone filter off each.

Lastly and easiest would be to run some sort of custom ~45ppi oiled sock that would cover each horn individually with some sort of metal grate to prevent it from getting sucked in.

As far as the actuator could you incorporate the stock actuator to open the butterfly's?