Your dream non-direct port nitrous kit?
#1
Your dream non-direct port nitrous kit?
For a VQ35HR:
-Dual 10lb bottles
-4 nozzles (wet, two for each intake, 50hp/100hp single or combined for 150hp, switchable on the fly)
-Primary/Secondary solenoids (for backup/safety purposes)
-RPM based programmable progressive controller / window switch
-Dual bottle warmers w/ pressure control
-Dual a/f cutoff/safety switches plugged into wideband o2's, one mounted on each header collector to monitor each bank of 3 cylinders
-Remote bottle openers
-Custom switch plate mounted in the small box above the stereo
-MSD Digital Ignition w/ built-in timing retard
What's yours?
Added: The cost is $2145 for everything minus welding of the o2 bungs into the exhaust. I'm sure I could put it together cheaper if I shopped the prices around, but $2000 give or take is what it would be.
-Dual 10lb bottles
-4 nozzles (wet, two for each intake, 50hp/100hp single or combined for 150hp, switchable on the fly)
-Primary/Secondary solenoids (for backup/safety purposes)
-RPM based programmable progressive controller / window switch
-Dual bottle warmers w/ pressure control
-Dual a/f cutoff/safety switches plugged into wideband o2's, one mounted on each header collector to monitor each bank of 3 cylinders
-Remote bottle openers
-Custom switch plate mounted in the small box above the stereo
-MSD Digital Ignition w/ built-in timing retard
What's yours?
Added: The cost is $2145 for everything minus welding of the o2 bungs into the exhaust. I'm sure I could put it together cheaper if I shopped the prices around, but $2000 give or take is what it would be.
Last edited by procrit; 02-27-2009 at 01:30 PM.
Thread
Thread Starter
Forum
Replies
Last Post