Can I tap ECU Pin 62 for the tach signal for my MSD 8969?
#1
Registered User
Thread Starter
Can I tap ECU Pin 62 for the tach signal for my MSD 8969?
Should I have any problem picking up a tach signal from ECU Pin 62 (Ignition coil No.1 which is also Pin 1 of connector F203) for my MSD 8969 Window Switch? Thanks in advance for your help.
2004 Enthusiast 5Spd
ZEX Wet Kit P/N 82220
2004 Enthusiast 5Spd
ZEX Wet Kit P/N 82220
#2
350Z-holic
iTrader: (13)
Just curious - what will your window switch control? nitrous?
#3
Registered User
Thread Starter
Yes, it will control when the additional fuel and nitrous (Wet System) comes on at a minimum rpm and off at a maximum rpm. You don't want the system firing at low rpm (Below 2500-3000) and you must have it off before you hit the rev limiter (6600). I've read the ideal "window" is from 3000 to 6000 rpm but shifting at 5500 rpm for best performance.
#4
350Z-holic
iTrader: (13)
Yes, it will control when the additional fuel and nitrous (Wet System) comes on at a minimum rpm and off at a maximum rpm. You don't want the system firing at low rpm (Below 2500-3000) and you must have it off before you hit the rev limiter (6600). I've read the ideal "window" is from 3000 to 6000 rpm but shifting at 5500 rpm for best performance.
#5
Registered User
Thread Starter
The kit is complete, but...it only works if I bypass the MSD 8969 Window Switch by providing a temporary ground to the Nitrous Management Unit. The window switch is operational and reads the correct rpm when in use but is dragging my idle rpm down when I arm the system. Further trouble shooting will continue but...my daughter is getting married this weekend. The 55 HP shot sure is sweet! See the photos here and thank you for your interest: https://my350z.com/forum/2003-2009-n...l#post10988272
Thread
Thread Starter
Forum
Replies
Last Post
RedBullRR
Maintenance & Repair
11
04-01-2010 05:53 AM