I had Zcargarage put on front and rear camber kits. I told Rob that my car was running really crappy, so Rob suggested I dyno my car to see whether my car is running correctly. After the dyno, Rob told me that my AFCII was pulling fuel at idle, and that was the reason why my car's idle fluctuates. He then proceed to adjust my AFC so the car would run better. But my car would ping at certain RPM which ROb will try to figure out next week when i take my car in for a header install. He said it could be my plugs are fouled, or it could be other things. I will let him figure all that out. But i dynoed at 245 whp and 235 trq.
My mods are JWT, kinetix v+ plenum, strup test pipe, HKS Ti exhaust, and ground wires. Are the numbers ok or it could've been higher?

 

Kind of hard to tell if you don't have a baseline dyno to compare to.

 

hey.... when are we going to have sjsu meet? i wanna hear how ure car sounds like with those test pipes. well i have pop, 5/16, and nismo exhaust, so i should be making maybe.... at least 10-15 less than u (conservatively). i am getting dynoed on sunday at that even in concord. so, we'll see....

 

I don't know. Maybe we can meet next weekend at SJSU parking structure??

 

my classes are tuesdays and thursdays from 540-7. Right at 7 on the roof of 10th st garage, when the sun is going down, it looks soooo perfect for a photo shoot. im busy next sat......maybe we should meet there sunday or something and do a drive.... sj hills are rite there.....

 

what kinda camber kit did you get and how much? thanks

ps
good luck on the problem fix

 

Cusco front camber kit and SPC for the rears. Cusco from Intense motorsport, $389 shipped. SPC from Z1 auto, $206 shipped.

 

My car is vibrating like crazy....I think my Kinetix plenum is rubbing against my front STB which is causing my front chasis to vibrate when accelerating. You could actually hear something is touching the front. I'm going to bring the car back to Zcargarage to have them adjust the brace. What do you guys think? I had camber kit installed and dyno tuned today. I think they might have forgotten to adjust the brace or something.

 

245? do i heard SC or F/I soon vince?

 

LOl, yeah, i'm seriously thinking about it. Most likely a supercharger.

 

Crap...there's no catching up to Vince now...

I used to have a weight advantage, until I bought Vince's rims, now I'm SOL hahaha...

 

DO ITTTTTTTTTTTT....DO ITTTTTTTTTTTTTT

 

Hey Tuan, Jondimellow and I are thinking about meeting up next sunday at SJSU 10th street garage to meet up and go for a drive. Let me know if your down.

 

I might end up getting a used Vortec from here. Do you have any hookups?

 

I'm not in the SC/FI scene; so i don't have any hookup.

 

I Have About The Same Mods As You And Im Pulling 262whp And 242tq, But I Have A Utec!!!! It Could Be Higher!!!

 

I was told that Unichip was a good choice. I'm sure Unichip will boost my hp to where you are at.

 

Yeah definitely. Once you get all those breathing mods you need a tune/Unichip to really wake them up.

 

+1

My car baselined at 242 w/ NO MODS!!!

Get the chip and tune her up!!!

 

Damn, thats pretty good. I think i might have an exhaust leak and my car pings. Willt ry to figure all that out next week at Zcar..Hopefully I will pull some good numbers after the header install.