DIY switchblade key fob, where you got ur key cut?
#1
Registered User
Thread Starter
iTrader: (2)
Join Date: Feb 2009
Location: Cali
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
DIY switchblade key fob, where you got ur key cut?
Hey All,
As some of you know or have already did this DIY switchblade keyfob. I wanted to ask where did you go in the bay area to get the key cut? I have tried a few places but they turned me down. I have gotten one key cut at a locksmith but it didn't work so i had to trash the key. I am just acquiring where you have gone with a good success that they can cut the key right.
Thanks
As some of you know or have already did this DIY switchblade keyfob. I wanted to ask where did you go in the bay area to get the key cut? I have tried a few places but they turned me down. I have gotten one key cut at a locksmith but it didn't work so i had to trash the key. I am just acquiring where you have gone with a good success that they can cut the key right.
Thanks
Trending Topics
#8
Registered User
iTrader: (2)
Join Date: Nov 2003
Location: NorCal
Posts: 179
Likes: 0
Received 0 Likes
on
0 Posts
I went to Home Depot. Make sure you take out the chip because no one will do it with the chip present. You will still get some resistance but they have a machine that check for the chip. Since you dont have the chip, you can press them to test it. Mine was done after I proved this.
#11
Registered User
Thread Starter
iTrader: (2)
Join Date: Feb 2009
Location: Cali
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
I went to an ace hardware and they couldn't do it because they said i had a chip, then i went to homedepot and they said the round part of the blade doesn't fit their machine so they couldn't do it. I just got the run around each time and i finally went to a lock smith and he screwed it up. So i just wanted to find a place that will do it without all the non sense.
i will take out the chip next time on my key and say it doesn't have one.
i will take out the chip next time on my key and say it doesn't have one.
Thread
Thread Starter
Forum
Replies
Last Post
lolwatbro
Maintenance & Repair
9
10-09-2021 04:58 AM
Tochigi_236
Feedback & Suggestions for Our Forum
8
09-27-2015 03:40 PM