PowerLab: Stage 5 Turbo Kit/ProEFI ECU/Intense 797WHP **Video**
#87
Sponsor
Intense Motorsports
Intense Motorsports
Thread Starter
iTrader: (1)
Join Date: Apr 2007
Location: In the LAB
Posts: 383
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by tig488
so it made over 1000whp?
#91
New Member
iTrader: (4)
Join Date: Feb 2005
Location: Get out my way pimpin, VA
Posts: 22,913
Received 2,448 Likes
on
1,769 Posts
Originally Posted by IntenseFab
Well what's the record for an unsleeved 3.5L engine? I haven't seen alot of dyno charts for unsleeved engines but i've seen 855WHP on a 4.2L stroker (which we surpassed today) we ran out of injector, so we wired in some RC 1200CC injectors this afternoon, and then we're going to go back at it tomorrow .
How much earlier did the spool come on after fixing the exhaust leak?
#92
Sponsor
Intense Motorsports
Intense Motorsports
Thread Starter
iTrader: (1)
Join Date: Apr 2007
Location: In the LAB
Posts: 383
Likes: 0
Received 0 Likes
on
0 Posts
And for all of you guys wondering, yes there are plans to make this kit into production.. For all of the people that purchase the stage 1/1.5 turbo systems, Alot of the same piping will still work with the stage 5 System (if you decide that 650-700whp isn't enough). They supplied us with the following to make this complete and compatible with our current stage 1.5 kit.
- New Driver side header
- New Crossover pipe
- 3.5'' Downpipe
- New Coolant Water Lines
- Full T4 76mm Non Ball Bearing Turbo
- New Oil Feed and Oil Drain lines
The installation was pretty straight forward, all of the intercooler piping is the exact same as the stage 1-1.5 kits. They also supplied us with a trick 4'' y-pipe back single exit exhaust system, which is compatible with any factory or upgraded y-pipe.
- New Driver side header
- New Crossover pipe
- 3.5'' Downpipe
- New Coolant Water Lines
- Full T4 76mm Non Ball Bearing Turbo
- New Oil Feed and Oil Drain lines
The installation was pretty straight forward, all of the intercooler piping is the exact same as the stage 1-1.5 kits. They also supplied us with a trick 4'' y-pipe back single exit exhaust system, which is compatible with any factory or upgraded y-pipe.
#93
New Member
iTrader: (4)
Join Date: Feb 2005
Location: Get out my way pimpin, VA
Posts: 22,913
Received 2,448 Likes
on
1,769 Posts
Any plans for an HR kit?
#97
New Member
iTrader: (4)
Join Date: Feb 2005
Location: Get out my way pimpin, VA
Posts: 22,913
Received 2,448 Likes
on
1,769 Posts
Originally Posted by IntenseFab
Yes.
What are your thoughts on the HTA turbos (not sure if you read my post on them)?
#98
Sponsor
Intense Motorsports
Intense Motorsports
Thread Starter
iTrader: (1)
Join Date: Apr 2007
Location: In the LAB
Posts: 383
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by z33boi
what type of dyno are you guys using?
Last edited by IntenseFab; 12-06-2007 at 06:46 PM.