Z part weights... with pictures
#161
6 inch cawk is my fave!
iTrader: (3)
Yeah that 15lbs seems like a conservative estimate, I pulled the wiring harness that had no purpose also it was 1/2 lb and then cleaned up the other sides wiring also... I cant believe they ran a harness from the front to back with nothing plugged into it. And it took some serious brain strain for my dumb *** to figure out how to unhook it...
I dont think my scale Is very accurate for light weights.
I dont think my scale Is very accurate for light weights.
The following users liked this post:
rustyschopshop (09-04-2016)
#163
6 inch cawk is my fave!
iTrader: (3)
I believe thats what that harness was, I guess it wasnt needed because it wasnt hooked to anything.
I just noticed that I have the same scale as op... Dicks sporting goods $10 purchase ftw
Took off the rear tie down hook... About a pount and a half.
I just noticed that I have the same scale as op... Dicks sporting goods $10 purchase ftw
Took off the rear tie down hook... About a pount and a half.
Last edited by dboyzalter; 09-08-2016 at 04:03 PM.
#164
350Z-holic
iTrader: (13)
#166
350Z-holic
iTrader: (13)
Has anyone weighed the fuel tank?
#167
6 inch cawk is my fave!
iTrader: (3)
If the G35 tank is the same as the Z tank I can get it but it might take a month or so... Its almost drained but I've run out of fuel containers... It's pretty heavy when its still got gas in it...
Probably not more than 20 lbs guesstimate...
Ac compressor feels like a lot but only a little over 7 lbs
Not needed pully 3.4
Stock manifold 6.8
Brembo front caliper 7.4
Brembo front rotor 20
Probably not more than 20 lbs guesstimate...
Ac compressor feels like a lot but only a little over 7 lbs
Not needed pully 3.4
Stock manifold 6.8
Brembo front caliper 7.4
Brembo front rotor 20
#168
350Z-holic
iTrader: (13)
#170
350Z-holic
iTrader: (13)
In conjunction with post #122 on page 3 (of this thread).
Passenger side window glass 10.4lbs
Passenger side window regulator - 5.0lbs
Passenger side plate (verifying post #122) 4.5lbs
+/- 20lbs per side
Last edited by bealljk; 02-23-2018 at 10:13 PM.
#171
350Z-holic
iTrader: (13)
picked these off the CL ... need a daily driver set of wheels. I believe they are the g37 sport wheels by enkei 18x8 with a 43mm offset (cleared my AP 4piston by about 1/4")
22.71 lbs / 23lbs
22.71 lbs / 23lbs
Last edited by bealljk; 05-04-2018 at 11:42 PM.
#172
I don't remember the total weights but I do remember the difference between the rear hatch OEM and the Siebon dry carbon fiber one is 36 pounds and that in not accounting for that weight they mount to the underside from the factory hatch.
#173
350Z-holic
iTrader: (13)
Weight of the gas tank: 39lbs with basket and driver side level gauge
Last edited by bealljk; 04-18-2020 at 10:20 AM.
The following users liked this post:
rustyschopshop (04-18-2020)
#174
350Z-holic
iTrader: (13)
Incase anyone is wondering ... the subframe (by itself) is right around 40lbs.
Last edited by bealljk; 05-02-2020 at 11:09 AM.
#177
#178
350Z-holic
iTrader: (13)
I tried closing a roof panel bc I forked mine out and what DK said ... the panel is very very very difficult to cut out ... I had that black parts car z33 and I chopped the entire roof section out and could not cut the panel out ...
but it is indeed crazy heavy bc the structural element of the roof ...
but it is indeed crazy heavy bc the structural element of the roof ...
Thread
Thread Starter
Forum
Replies
Last Post