laze1

iTrader: (17)

these parts are for a 2003-2008 Nissan 350Z

Shipping not included...located in Atlanta GA 30215

Tein Flex Control Master Complete Coil-over F & R (rebuilt in 2009) $1200 OBO
Currently setup for manual “clickers’ adjustments
12k/670 LB springs F&R
Adjustable ride height F & R

EDFC Controller, with all cables and screws for the top of the shock, and Adjustment tools (spanners) $200

http://www.tein.com/products/flex.html
http://www.tein.com/tech_info/p26.html

Hotchkis F & R adjustable sway bars $300 OBO

Gsedan35

iTrader: (10)

In case your buyers would like to know the min and max drop specs for what your selling.

Tein flex drop specs 350z
Min drop +1.3”/+.1”
Max drop -2.3”/-1/3”
Recommended -.9”/.8”

http://www.tein.com/price/index.html

JRed350z

iTrader: (3)

pm'ed! Also about how many miles would you say are on the coilovers and on the sway bars? Also do u have any pics showing the drop with these coilovers in ur car

laze1

iTrader: (17)

I am just a little lower than stock...but you can run these up and down as you would like

as far as miles, these have less than 2000-3000 miles as they have been used on a road racing car...

CRIDDA

iTrader: (10)

Bump for a good and honest guy

laze1

iTrader: (17)

At the request of potential buyers, I looked for more of the EFDC parts...and I found them. The EDFC was on the car when I purchased it, but I removed them and installed manual adjusters.

So, this is what I have:

EDFC Controller for the coil=overs I have listed here...likely ~5 years old
4x cables to the shocks
1x main power cable,
4x motors with 4x rubber dust covers,
4x screws for the top of the shocks,
3x adjustment tools (spanners)

I think the controller had 16 adjustments...but not sure..it has been 3 years and I never used it other than to confirm it worked when I purchased the car.

$200 Plus shipping

Note: I believe one cable may be cut/damaged when I removed them. However I believe it can be repaired by soldering the cut wire. However these are being SOLD AS_IS!!!! but it should s\work...just not guaranteeing that

atlgcoupe77

Hey laze1 im located in cartersville ga I have seen you on vqfrenzy if you could hmu im very interested. My email is distortedcoupe@gmail.com or hmu on vqfrenzy sn is it-g35 I have cash ready and will meet you. Was gonna go to z1 friday and get bc's. Just email or message me I'll give u my number. Thanks josh.

laze1

iTrader: (17)

email sent...they are yours!

laze1

iTrader: (17)

SOLD

thread closed