Im looking for someone who can raise my rev limiter/ idle in texas? Im hoping someone with a cipher or something, I will come to you, and will pay you. Thanks

 

www.uprev.com is the shizznit..

 

Im hoping someone has a cipher or something, I dont have the time to have my car down for a week or more.

 

It wouldnt take a week to take it to uprev and get the car done.

 

it would take less than 3 hrs if u have them tune it too.

 

Ok so i drive to austin, and have it done? How much would they charge? Anyone have a coach for me to sleep on?

 

It literally took 10mins for my flash.. They may have a couch for you.. lol. jk.. hotel would suffice.. Actually u dont need to stay long.. so u would be back to Dallas in no time!!

 

How much did it cost? Did they tune it for your vehicle? Or by mods?

 

Plan on $500-$700 for a flash, tune, maps and dyno...call them!

 

Wow, it's THAT much?

 

Yeah...i could just add another 300 to that and get utec installed and tuned.

Yo Mackie...i might go with you.

 

When will you be going to Austin? I've been to UpRev a couple of times, but they were closed both times I was there.

 

Utec for less then 1000? I would sure like to see that. Anyways if you guys come to town call me. I can meet yall at UpRev.

 

You have to call ahead of time. They only work when they have cars to tune.

 

Brand spankin new installed and tuned.

 

Are you saying you just did that or what?

 

^^^Not yet, but if i do...my price is under $1000 tuned.

 

Your price or can we get the same hookup?

 

I'm pretty sure it's my price...i'll see. I'm not sure if too many of these can go out the door.

 

If you only need the idle raised < 250 RPMs (w/ Cipher) we'll do that for free, just call ahead of time to make sure someone is there, or email for an appointment. We're almost always around Mon-Fri noon-6:30pm, but we travel quite a bit.

The rev limiter requires a reflash, so that's $300 (stage 0), and we could hard code the idle at that time as well (rising the idle w/ Cipher is only semi-permanent so it can be changed back w/ the dealer tool or an ECU reset).

A full blown dyno tune typically runs between 700-850 and takes ~1/2 a day.

Jared@UpRev