is there a way in the software for you to confirm the target A/F is working?

my EU is wired up with a boost pressure sensor and harness and then using another pressure sensor harness to wire into my Innovative A/F gauge.

but how can I tell it's working?

 

not to be captain obvious here but, what are your AFRs?? if they are what you put the target af at then its working..



EDIT. to make sure you understand what you are putting in there. the target AF ratio is a figure that you put in to change the fuel map to adjust enough fuel to get your TARGET figure that you put in. there is a gain that makes it adjust faster or slower on the EU. if it is working properly you will put in say 11.4 and your AF ratio should be exactly 11.4 all the way across the board.

 

yeah i'm pretty sure it isn't hitting exactly the target or it's off by a few decimal points. So was wondering if there's something that confirms the EU knows what's going on and not having to have faith that it's working or the wiring is soldered up right

 

now that i am not sure but i will let you know this weekend when i have more experience with the EU. i will be messing around tuning one this weekend...