Got my first dyno today. What do you guys think? Haven't got any aftermarket computer management... My mods are in my sig..

 

Looks like 3 good strong pulls. Congrats. They didn't do one pull to check A/F?

 

not bad not bad, now get it on the track and tell us what you run.

 

need air/fuel measurement to make a judgment! looks like decent dynojet numbers, but remember, they're JUST NUMBERS

 

Nice dyno, do you happen to know what SAE or actual numbers were?

 

On the sheet it say CF: STD smoothing 4 the would be alot lower if uncorrected or even SAE.

 

Corrected could be higher or lower. Just depends on the weather. Those are good numbers for a dynojet.

 

http://www.bishopsperformance.com/dynoinfo.htm

 

WHAT KIND OF test pipes do you have, 2.25 or 2.5 inch Inner diameter? Were u running the Track wheels on the dyno? What was your air/fuel were you lean?? shoulda been with those mods...

 

very nice stock numbers with your mods. If you show us the AF, we can tell you if there is more power on the table.

 

2.25" test pipes. I ran with the 19" Axis Shine rims listed in my sig. My a/f was a bit lean between 2700 and 3400rpms if I recall correctly. I'll see if I can get my a/f log from Sammy.

 

I bet you will be real happy with some EM and a tune.

 

That's funny, I have comparable mods and you went ballistic when I posted my dyno #s that were only 5 higher and the same torque

 

hey guys, finally got my af graphs. what do you think?

 

nice to see what you're putting down with just those simple mods. I haven't dyno my car for a long time. If you don't mind me asking, where did you get your dyno done?

 

Stillen in Costa Mesa

 

same place I got my last dyno done (back in 03). how much did they charge you? got a contact out there?

 

Looks like you def. need a TUNE!

 

someone tune me!!

 

I don't really want to go with a reflash for 500 bucks when I can get a piggy back (is that what they are called?) unit that can reprogrammed at any time... what should I get? -I hear people typing UTEC already......