I installed my maps today and cipher, the car runs amazing!!

Im going to be getting the car dyno'ed tomorrow and I want to log some cipher logs but I cant seem to figure it out from the instructions included on the disk, I wouldnt usually go on here and start a post on this but I have to figure this out before 10am tomorrow.

THanks so much guys!

 

If I were you, I'd call UpRev 1st thing in the marning... Or at least let the dyno guys call when they are ready to do your pulls.

 

I did he said to email Jared, I did but he might not get back to me in time.

The place im getting the car dynoed at doesnt have a clue what Cipher is or Uprev.

 

I just need to know what to select when recording ECU stuff. It only lets me check 20 and I need to know the right ones.

Thanks Guys

 

Comeone anybody!!!!

 

* AFR Bank 1 and Bank 2 (See Cipher user guide)
* Accelerator position (either one)
* Base fuel schedule
* Calculated load
* Coolant temp
* Engine speed (RPM)
* Ignition timing advance
* Throttle position (either one)

http://www.uprev.com/updates/Cipher_...uide_v1.03.pdf

 

Ive been looking at that manual but it doesnt say what in detail to check.

Thanks so much!!!!