im wondering how well the motors can handle nitrous im bout to get the 07-08 350z and wanna put a 100shot on can anyone tell me if it could handle that.

 

Yes

 

Maybe

 

Possible

 

depends

 

Not certain if the 350Z can handle 100 shot, but I know that the RSX can. My buddy has one. Type-R.

 

I'm sure the Z can handle it, but if I were you I would try a 75 shot to be on the safe side.

 

I'm on the verge of doing it too, the setup I'm using is:
Dynotune Nitrous Kit for VQ35HR
Purge Kit
Bottle Heater
And their RPM Window Switch, which would prevent it from kicking in in 1st gear for traction purposes, and it would only kick in from 4000 to 7000 rpms to ease the torque stress on the engine and prevent me from missing a gear and going boom.

Heres a thread of a G37 with an HR engine uing an NX kit:
http://www.myg37.com/forums/engine-d...ll-vq35hr.html

And a video of a Zex 75 shot on a 350z HR intall and dyno:
http://www.cpgnationtv.com/video_detail.php?mId=9512

 

RSX can handle anything...

 

Seriously? No flaming yet?

 

^Sarcasm radar is down

 

+1...

 

Allow me to correct my post: "Seriously? No *outright* flaming yet?"

 

....you both joined on the same date.

 

You'll be lucky if it doesn't blow the welds on the intake

 

This +1. Unless you get the new mythical manifold that will be available on the Friday after next Friday after the full moon shines and the wolf howls heartily. I hear it's a must have for going F/I, and why not shooting some spray too?

 

make sure when you do the install that you weld the valves in because the extra pressure for the Nitrous oxide will blow them out of the block....

and do a search button install

 

Where can I get one of those?

 

Look in the Nitrous sub forum for more info, there's a couple HRs spraying and some are at and over 100 shot.