10.5" rear +30 offset flush with fender?
#1
10.5" rear +30 offset flush with fender?
Hi, my question is will a 19x10.5" +30 offset rear wheel look flush with the fender? I know most people go with a +22-24 offset in the rear, so i was wondering if +30 would still look good and flush. Any thoughts are welcomed.
Last edited by slowxturtle; 06-27-2005 at 03:41 PM.
#2
a 30 would be flush if you ran 0 camber. but since mmost of us are at -1.5 or around there the rim doesnt look flush on 30 offset. if the wheel you want is offered in a lower offset get it. i have 10.5 w/ 30 of. and i think it looks good but if i had the choice i would have gone with a 22
#3
to correct the camber to 0, can you just get an allignment or would you have to get a camber kit? Or are you not suppose to change the -1.5 camber? Mario, do you have pics of your wheels as they sit with the fender?
#4
This will vary with the type of rim and your camber. I am not going to go in to details since I am not a wheel expert, but different companies utilize different disks sometimes, which effect clearance
Trending Topics
#13
20x10 w 25 offset
should be close to 10.5 with 30 offset
i got 20x10 with pirelli 285 30 20
rear camber is at -2.4
non-directional tires
$430 each
i get aboout 5 to 6000 miles on rear tires
and i love it.
Last edited by de_only_Z_2_c; 06-28-2005 at 05:06 PM.
#14
It will still look very nice, but if flush is the goal then +22 would get you closer. I'm running 10.5 +22 with -1.8 degrees of camber and 285/35/19 tires. Had to roll the fenders with this setup but the end result is as close to flush as I feel comfortable going. I did see 295/30/19 with the same specs, though his fenders were cut.
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM