I just purchased 4 A.Z.A Z2's for my 05 Touring (non Brembo) and they are not fitting! There is a bolt between two of the lugs on the wheel well that is stopping the wheel from sliding into place onto the lugs. The specs are:

F - 19X8.5 5X4.5-38
R - 19X9.5 5X4.5-38

They were ordered from WheelMax.com and should have been verified to fit my car before ordering/shipping. I am now waiting on a call back from the service manager.

Has anyone heard of this problem before? It is definitely the bolt between two lugs on the well stopping the wheel from going on.

Help!

T

 

u have to take that bolt off its there so that people dont put the stock wheels on the wrong side

 

So basically you're complaining to a good company that you don't know what you're doing.

 

ever think to just take it off and see if it was ok?

your money>brains

searching really could have avoided this thread.

 

If I had $1 for as many times this question was asked, I would have had my turbo by now.

 

It's amazing. One helpful remark out of a handfull smart****.

There is a first time for everything. This was my first time coming across this........

Thanks Ice!

T

 

^ +1...this site is full of jerks...don't worry about it

 

...I love the Whie Sox

 

White Sox of course

 

you also got horrible offsets, in case you didnt know that either. your car is gonna look like an 80s hotwheels toy.

 

....that does say -38 correct???

 

im sure he means +38 offset, since they are aza wheels... and still.. they are bad offsets, hes gonna need near a 20mm spacer just to get them to fit right.

 

probably a 15-20 for the front and and 10-15 for the rear.

 

take off the brake rotor holder bolt. It's there to keep the rotor in place when you take off the wheels. Wheel lugs secure the rotors in place after you put on the wheels.

BTW, dont mind these guys in here. They always laugh at "what they think stupid" questions. But to me, the only stupid questions are the one you don't ask.