I like the Touge's I have and would rather not spend out the nose for a new set of wheels I dont like that I would be setteling for. I just need to get one set width bumped up 3 inches to 12". Essential I'm moving the rear 10's to the front and the new 12's the rear. Even if its a couple of hundred its still way cheaper than getting a whole new set of that calaber, and these will hold the power too.

Thanks.

EDIT: Origanly couldnt find the site but I found it later so read post 2.

 

I was searching for half the day and decided to put up this thread. About 20 minutes later I found this :
http://www.weldcraftwheels.com/Wide.htm then did a search on here. Aparently there are a few guys here who've had it done.

So I guess this is turning to a how is your widened wheels holding up? And any recomendations?

https://my350z.com/forum/showthread....wheel+widening