Where can I purchase a set of 10 or 12mm spacers? I was going to make my own set out of some 7thousand series aluminum but someone mentioned they were cheap to buy.

Any idea where I can pick up a cheapy set? I may only need 2, now that I think about it. Ive seen them for 100+ but is that 1 or a whole set? I would HOPE a whole set. But like I said, I may only need 2.

Thanks

 

Someone will probably have a better solution than this but, a local machine shop could probably make them for you to the exact specs. Otherwise try www.summitracing.com or www.jegs.com , they usually carry generic ones.


Rob

 

Yup, I was going to cut my own, but if its cheaper to buy it then to make it, i will just buy it

 

http://store.summitracing.com/partdetail.asp?part=9325

which one of these would fit the z?

i am going to make them myself....but i need the specs!

also....am i going to need to get new bolts for the lug nuts (longer ones...or will the ones on there fit still??)

thanks,
djk

 

do a search for H&R wheels spacers, I found lots of info that way

 

You will need 60mm lug bolts which can be purchased just about anywhere.

Just tap them out with a hammer and push the new ones through.