ALO8

iTrader: (5)

any of you guys rubbing on the outer front fenders? Im tucking a little like this and when i turn it rubs on the outside of front fender

[/QUOTE]

seany boi

Some seriously sick cars in this thread !

NA&CH

iTrader: (74)

I doubt any of the gents running these setups even have the fender liners.

Chris thaat loooks SICK! The rear fenders flow so nice. I was at first saying thats a sick roll and pull. Very nice job!

Chris

Royal_T

iTrader: (9)

^^ to answer you question yes most if not all should have that inner liner taken out.. I tried to keep mine but when through two sets of them...lol

How do you like the 275/35 on your 18x13s, I am going to be running the same tire size for mine and just wanted your opinion...

KingBaby

iTrader: (3)

You can keep them, just have to trim out the top of them where the tire would make contact!

DeeSan

iTrader: (3)

thanks 18x11 -4 245/35

It used to rub and push the fenders back when I had 245/40. Since I'm running 245/35 car is a tad lower and I can turn full lock at any speed and absolutely no rubbing at all ! I still have my fender liners as well, all you have to do is trim them a little and they're good to stay !

LeviEubanks

Does anyone else see the creepy guy with the mustache in the window?

sofa king

iTrader: (25)

LOVE the black equips

chris05ppwZ

iTrader: (2)

They are fine, been on some bad roads with them. They are showing a decent amount of barrel though but the are holding up pretty well and i've even slid on them a few times and nothing has happened haha.

Tomci08

iTrader: (32)

Anyone running a 215 35 19 on a 9.5 wheel up front or a 245 35 19 on a 10.5 rear? Wheels have offset of 0. From looking around it seems majority recommends that 225 / 255 is best.

VMRWheels

Well, I did look at your location before asking haha. I live pretty close to you then, probably about 15 minutes down the road.

Surprised I've never seen you cruising around before.

joshie3.5.0.z

so does anyone know how my z will sit if i get 19x9.5 +5
19x11 -2
will it sit flush or should i get -8 back, -3 front?

KingBaby

iTrader: (3)

too many variables to figure out the flushness

height?
camber?
tire selection?
stock fenders?
*****?

joshie3.5.0.z

im at stock height but i plan on slamming it , im on stock fenders but plan on getting them rolled and maybe a little pull if needed, and as of right now i dont plan on getting a camber kit unless needed

joshie3.5.0.z

what size are your rims and offsets? and what kind of fender work you have done looks great by the way

joshie3.5.0.z

what the off set and sizing on your rims ?

KingBaby

iTrader: (3)

Will be needed!

What's all in this plan of yours?

Rims
Camber kit
Coils

joshie3.5.0.z

rims camber kit coils bumper fender work
how agressive do you think 19x10-2
19x11-2 will be? pics?

DeeSan

iTrader: (3)

^10-2 is a lot better. 9.5 +5 is far from it!

.eoJ

iTrader: (1)

Thanks, they're 19x11 +2 and 19x11.5 -4 with just a fender roll