I ordered Nismo wheels (finally). They are the 18" 8.5 +25 front and 9.5 +30 rear. My fenders are rolled. I was wondering if anyone runs any spacers on these particular wheels. Thx

 

people do and so should you

 

How far do you want to move the wheels? 5 mm? 10 mm? 20 mm? There you go.

 

I have the 19"s and I'm running 15mm in the front and 20mm in the back.

 

I just got my Nismo wheels 18 x 9.5 all around, I have never used a spacer before and don't know much about sizes, which would be the appropiate size to use?

 

I have the same setup and I wish they had a little more agressive fitment. I'm not to crazy about spacers, but they should look ok. I'm just going to man up and order the 18x10.5 for the rear and move the 18x9.5 to the front.

 

didn't know there was an 18 x 10.5, how much are they?

 

You have to order them from Japan. I have had several different quotes on them. They cost a lot more and about up to a 6 month wait, but IMO it's worth it. $600-900 each shipped is what I have found. I'm planning on the 18x10.5 +15 offset. I just want something different.

 

Damn that sounds nice, but a 6 month wait? But I think it's worth it too.

 

I'll be ordering them later this year after I get my suspension all sorted out. Hopefully they will be here by spring for some new rubber.

 

Where did you order them from Redmike? I might be interested soon...