hey im sure you guys might have already answered this but i have a 06 with the stock oem 06-08 wheels and im looking to put spacers on it for now.. i want them to be flush with the fenders. do u know what mm spacer it would be?

 

your joking right?

 

no im serious and if you dont want to help out then keep it to your self!!

 

just a hint of advice.. READ THE THREAD!

 

i am new to the threads.... i read and saw what you did to yours... wanted to see if any one else did it and what looked better 20mm or 25mm

 

dude.... i started the thread, and i obviously wont help since this question has been answered not only a million times BUT ON THE FIRST PAGE


so...

 

What spacer brand did you guys go with and where did you buy it?

 

+1. subscribed!

 

i got h&r ones, used

if you search in the wheels marketplace you will find some for sale

IT REALLY CHANGES THE CAR! DONT THINK TWICE ABOUT THIS MOD IF YOU HAVE STOCK WHEELS!!! its a must!

 

OP were you able to fit the 25mm spacers in the rear with the GF210s and 265s??

I have 25mm rear spacers and 15mm spacers in the front on OEM 03-05s (18x8 all around, I'm fairly sure they are same size specs as the 06+ OEMs). Lowered on Eibach Sportlines, which is just slightly lower than the GF210s.

I am running 245s in the rear, and with -2 degrees of camber I was rubbing with the 25mm spacers. I rolled my fenders to fix the problem. I rub every once in a while in the front with the 15mm spacers, but not enough to make me want to do anything about it.

I have more pics in my albums, but the 25r/15f is very flush:






I don't think I could go 30mm in the rear.

 

also, I am using SPC front/rear/toe. My spacers are Project Kics; I STRONGLY recommend you save yourself some time and get spacers with built-in studs (such as Project Kics). Takes 10 minutes to install.

 

any suggestions on where to purchase spacers?

thanks

 

we have plenty of great site sponsors, always check with them first in the marketplace section.