When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Here is my old set-up:
275/30/19 front on a 19x9 +31
305/30/19 rear on a 19x10.5 +28
Never any rubbing, even under full compression, and no fenders rolled
I wasn't, but the car was fully-deflected, and did not rub. I tried a similar set-up with +22 wheels, and I was able to make it rub. This set-up would not rub even after lowering.
Crom what is your wheel offset? I just purchased 295/30/19 and I really dont want to cut the fender. You think you can get away with just rolling the fender?
Crom what is your wheel offset? I just purchased 295/30/19 and I really dont want to cut the fender. You think you can get away with just rolling the fender?
The LE's are +22 but I only have a mild roll - ( 10 oclock to 2 ) since I had some bondo work done and didn't want it to crack. My only option is to cut. But you should be able to get away w/ some more camber and a aggrssive roll.
[ PICTURE REQUEST ] Work Meister S1 3P _ 19x11 +17 with 295/30 or 305/30. Because I want to upgrade my 285/30. My fenders are fully flat/rolled. I'm wondering how it looks. Thanks!
Crom what is your wheel offset? I just purchased 295/30/19 and I really dont want to cut the fender. You think you can get away with just rolling the fender?
Just got back from buttonwillow on sun...my setup was pretty mismatched. ( 245's front 295's rear...but still had tons of fun. What a huge difference. I love the new traction. I'll be trimming a little more out of the fenders this weekend and dialing the camber back from -3 to -2 to help even more.