I have done many 19x9.5 and 19x10.5 all have to roll the rear fender.

 

im thinking of buiyng a TE37 19x8.5 F ,19xx9.5 R with 22mm offset all around n will i have to roll fender

 

<<It'll rub. Those who tell you that it won't, are fooling themselves because they made a very expensive mistake.>>

Now why would I waste my time by coming on here and telling someone that my car doesn't rub, when it does??? sheesh

I have yet to bottom out or contact the fender area with my cars set-up. If it did, wouldn't you think I'd just get my fenders rolled? I mean, I've already spent $10k on my 350Z, whats another $160.00?

Fact of the matter is, I have the 10.5" wide LE37T and I have RS*R springs and after 1200 miles on all kinds of bumpy roads I've yet to have the fender contact the tire, even on an aggressive sweeping on-ramp at over 50 mph with a passenger AND a full tank of gas....

I am as surprised as anyone...but that is fact, NOT blowing smoke up someones *ss....

 

Sorry about that, I was thinking that you were going with a tire that are wider then 275/35.


<im thinking of buiyng a TE37 19x8.5 F ,19xx9.5 R with 22mm offset all around n will i have to roll fender>

As long as you don't go with anything wider then 275/35 then no problem.

 

Yep, I just have the lil skinny 275/35-19s..heh

 

Another PR Z gone .... at least it wasn't as bad as heriberto's.

Are you having trouble finding another one down there ?
Where on the island was the accident?

When my sister was looking for one all of the dealers were asking a HUGE mark up. She just went with the FX instead.

Good luck getting a new one

jim