FS: 2006 350z Base MT White (built engine) NM
Its time for me to move on to something different. I have owned this car since new, I am the only owner. The engine had a factory defect at 6,000 miles or so. I had built Z motors build a engine for it in 2008. Everything works on it. Currently has 55,500 or so miles on it. It does have some paint imperfections from being used a daily driver / road trip car. It has no cruise control or traction control being a base model.
I am asking 13,000 obo.Make me an offer the worst I can say is no..
I will not trade it for anything. I want it sold. I always said I would turbo but I can never find the time to do it.
Mods to the car-
9.1:1 Arias ED pistons
Eagle H beam rods
1/2" Arp head studs
Arp Bolts in bottom end along with ACL bearings.
JWT S7 cams (RevUp cams) along with JWT springs / retainers
The heads were CCed by the machine shop, so all cylinders have the same compression ratio.
Engine is fully balanced
JWT Flywheel
Southbend DXD road race clutch currently in the car, 10k miles or so on the clutch
HKS head gaskets
Ebay long tube headers - have been on for 3 years without cracking.
Fast Intentions 2.5 true dual exhaust with x pipe, stainless steel.
I still have the original cats to go with the car.
Limited slip with 3.55 gears.
New Tires, 700 miles or so on the tires.
The rims do have some curb rash, the car does have a few dings but it is really hard to notice due to it being white.
Will come with uprev tuning cable.
If you want a 350z to turbo this one would be great, no worries about blowing the motor. With proper cam tuning with uprev this motor will keep pulling past 7500rpms.
Location - Lovington NM 88260
Vin -JN1AZ34D66M306424
Phone - 575-5one7-987two Texting to contact me is faster than calling I get poor service while i'm at work.






I am asking 13,000 obo.Make me an offer the worst I can say is no..
I will not trade it for anything. I want it sold. I always said I would turbo but I can never find the time to do it.
Mods to the car-
9.1:1 Arias ED pistons
Eagle H beam rods
1/2" Arp head studs
Arp Bolts in bottom end along with ACL bearings.
JWT S7 cams (RevUp cams) along with JWT springs / retainers
The heads were CCed by the machine shop, so all cylinders have the same compression ratio.
Engine is fully balanced
JWT Flywheel
Southbend DXD road race clutch currently in the car, 10k miles or so on the clutch
HKS head gaskets
Ebay long tube headers - have been on for 3 years without cracking.
Fast Intentions 2.5 true dual exhaust with x pipe, stainless steel.
I still have the original cats to go with the car.
Limited slip with 3.55 gears.
New Tires, 700 miles or so on the tires.
The rims do have some curb rash, the car does have a few dings but it is really hard to notice due to it being white.
Will come with uprev tuning cable.
If you want a 350z to turbo this one would be great, no worries about blowing the motor. With proper cam tuning with uprev this motor will keep pulling past 7500rpms.
Location - Lovington NM 88260
Vin -JN1AZ34D66M306424
Phone - 575-5one7-987two Texting to contact me is faster than calling I get poor service while i'm at work.






Thread
Thread Starter
Forum
Replies
Last Post
bcoffee20
Zs & Gs For Sale
5
Nov 19, 2015 06:39 PM




