What have you done for your Z today?
Took her out yesterday to look at some 300ZXs around the area... Ever since I sold my 6MT Roadster I've been craving to drive a standard again. Decided I'm going to buy another car that I can play around with - straight cash. I looked at a white 1994 non-turbo 300ZX t-top for around $4k with 129,000 miles. Minor body issues but it drives great. Going back to check it out again tonight... Anything I should look out for?
The following users liked this post:
KingBaby (06-17-2016)
The following users liked this post:
KingBaby (06-17-2016)
New Member
iTrader: (13)
The following 3 users liked this post by mr. sparco:
New Member
I made it spend the day in the rain while I worked on my 280Z, ( has 240Z bumpers and 81 zx Turbo motor).
<a href="http://s638.photobucket.com/user/blufc3s/media/2007%20350Z/image_19.jpeg.html" target="_blank"><img src="http://i638.photobucket.com/albums/uu104/blufc3s/2007%20350Z/image_19.jpeg" border="0" alt=" photo image_19.jpeg"/></a>
<a href="http://s638.photobucket.com/user/blufc3s/media/2007%20350Z/image_19.jpeg.html" target="_blank"><img src="http://i638.photobucket.com/albums/uu104/blufc3s/2007%20350Z/image_19.jpeg" border="0" alt=" photo image_19.jpeg"/></a>
The following 3 users liked this post by blufc3s:
New Member
Hit the track yesterday and broke my record at Big Willow
The following users liked this post:
BigBlue (06-13-2016)
New Member
iTrader: (1)
Registered User
The following users liked this post:
KingBaby (06-17-2016)
New Member
iTrader: (1)
Well I decided to start and warm up and take my Z around the block before work this morning...
Covered in dirt from light rain and wind. I decided while it was warming up I should get a cup of water and wiper the front windshield of dirt. (Front ends still off no window fluid). Cars still on, I close my door to not get water inside the door when it wipes.
Put the cup down and realize FML!!! My keys are in, my stupid handle is broken and my car is on with the keys inside...
I have no rad fans so my car is going to over heat in maybe all of 5 min... Im scrambling trying to figure a way to shut it off and then figure out how to break into my car before my engine blows...
disconnect the battery.. God dam FML alternator -____-
Scrambling, scrambling... Ill choke it! Stuff a towel into the intake box...... Dam thing is still going for 3 min.. Ok fk... fk... fk.... By this point its been running for 6 7 8 min...
Ok Ill take off the intake box and chose the long tube to choke off. Take it off and chokes by too much air.......
Worst 10 min of my life. Then took another 10 to find a dam dry cleaners hanger to hook the door handle and let my dumb a** back in.
Covered in dirt from light rain and wind. I decided while it was warming up I should get a cup of water and wiper the front windshield of dirt. (Front ends still off no window fluid). Cars still on, I close my door to not get water inside the door when it wipes.
Put the cup down and realize FML!!! My keys are in, my stupid handle is broken and my car is on with the keys inside...
I have no rad fans so my car is going to over heat in maybe all of 5 min... Im scrambling trying to figure a way to shut it off and then figure out how to break into my car before my engine blows...
disconnect the battery.. God dam FML alternator -____-
Scrambling, scrambling... Ill choke it! Stuff a towel into the intake box...... Dam thing is still going for 3 min.. Ok fk... fk... fk.... By this point its been running for 6 7 8 min...
Ok Ill take off the intake box and chose the long tube to choke off. Take it off and chokes by too much air.......
Worst 10 min of my life. Then took another 10 to find a dam dry cleaners hanger to hook the door handle and let my dumb a** back in.
The following users liked this post:
BigBlue (06-15-2016)
New Member
iTrader: (4)
Oil change 4 qts. Mobil 1 full synthetic 5w30, 1 qt. Polydyn tx7 (been using it since car was broken in). Removed front bumper cover, cleaned the air filter even though it looked clean haha! Took advantage of it all off to inspect this and that under the car and even shined up the zspeed undershroud (makes the car faster!).
* I had added a new magnetic drain plug last time; I was glad to see that after 3K miles there was zero metal particles on the magnet.
Bought a 6 pk. of qts. of Torco Accelerator (Race fuel concentrate) that I like; 1 qt. per 20 gal. fuel mixes into basically a +4 octane. I have 91 oct. in this state and I think that the Torco product is very good and I like knowing that each tank I have is better overall fuel. The car is ready to roll.
* I had added a new magnetic drain plug last time; I was glad to see that after 3K miles there was zero metal particles on the magnet.
Bought a 6 pk. of qts. of Torco Accelerator (Race fuel concentrate) that I like; 1 qt. per 20 gal. fuel mixes into basically a +4 octane. I have 91 oct. in this state and I think that the Torco product is very good and I like knowing that each tank I have is better overall fuel. The car is ready to roll.
Last edited by BigBlue; 06-16-2016 at 02:28 PM.
The following users liked this post:
KingBaby (06-17-2016)
New Member
iTrader: (2)
WC Lathe Werks Stainless Piston Gunmetal Leather Wrapped Shift **** with Orange Stitching
WC Lathe Werks Stainless Piston Gunmetal Leather Wrapped Shift **** with Orange Stitching Installed
6 inch cawk is my fave!
iTrader: (3)
Not going to win any shows but we will see how it looks in a week after I can wet sand it.
Not like the car stays clean long enough to matter at this point anyways
Not like the car stays clean long enough to matter at this point anyways
Last edited by dboyzalter; 06-16-2016 at 12:45 PM.
New Member
put these
20160610_184934 by Malachi Rosales, on Flickr
and these 20160610_184714 by Malachi Rosales, on Flickr
20160611_122328 by Malachi Rosales, on Flickr
20160611_125648 by Malachi Rosales, on Flickr
20160611_135853 by Malachi Rosales, on Flickr
Check the exhaust! I need a tune cause the heat usually means running lean no? Look at the before and after the track
20160611_155403 by Malachi Rosales, on Flickr
20160612_150346 by Malachi Rosales, on Flickr
Its all purple now, uh oh
20160612_150354 by Malachi Rosales, on Flickr
20160612_150402 by Malachi Rosales, on Flickr
Pre-alignment so i was like negative a million
38071 by Malachi Rosales, on Flickr
20160610_184934 by Malachi Rosales, on Flickr
and these 20160610_184714 by Malachi Rosales, on Flickr
20160611_122328 by Malachi Rosales, on Flickr
20160611_125648 by Malachi Rosales, on Flickr
20160611_135853 by Malachi Rosales, on Flickr
Check the exhaust! I need a tune cause the heat usually means running lean no? Look at the before and after the track
20160611_155403 by Malachi Rosales, on Flickr
20160612_150346 by Malachi Rosales, on Flickr
Its all purple now, uh oh
20160612_150354 by Malachi Rosales, on Flickr
20160612_150402 by Malachi Rosales, on Flickr
Pre-alignment so i was like negative a million
38071 by Malachi Rosales, on Flickr
New Member
iTrader: (1)
The following users liked this post:
dboyzalter (06-17-2016)
New Member
iTrader: (1)
6 inch cawk is my fave!
iTrader: (3)
O I painted it with... Wait for it
Crustolyum gloss black engine paint...
Its a temporary fix so I can still drive around and not look completely messed up.. The lines that look like wrap are from masking tape... Next week ill wet sand it and put a gloss black 3m band aid over it untill I get around to touching up all my messed up parts at the same time with legitimate super black from painttouchup...
I have little messed up wrap covered sections on more than one spot on my car
But hey its a project fun car that I still drive so whatever im not bringing it to barret Jackson anytime soon..
For prep I sanded the back side with 60 grit... Put fiberglass resin and 3-4 strips of fiberglass..(as many as I could before it hardened) waited 2 hours.. Sanded around hole to bare metal bondo filled it even, sanded primed paint...
Goodbye antenna from 1971.
Crustolyum gloss black engine paint...
Its a temporary fix so I can still drive around and not look completely messed up.. The lines that look like wrap are from masking tape... Next week ill wet sand it and put a gloss black 3m band aid over it untill I get around to touching up all my messed up parts at the same time with legitimate super black from painttouchup...
I have little messed up wrap covered sections on more than one spot on my car
But hey its a project fun car that I still drive so whatever im not bringing it to barret Jackson anytime soon..
For prep I sanded the back side with 60 grit... Put fiberglass resin and 3-4 strips of fiberglass..(as many as I could before it hardened) waited 2 hours.. Sanded around hole to bare metal bondo filled it even, sanded primed paint...
Goodbye antenna from 1971.
New Member
Took the Z out for a short ride today for the first time since installing R1 Concept brake and rotors on it 3 weeks ago. I took her up to triple digits for a little while and I must say that as an 03 with 161k, she still runs great.
...and before anyone talks about how unsafe that is on public roads, you can only wish that you lived in Germany and have the ability to do it legally.
...and before anyone talks about how unsafe that is on public roads, you can only wish that you lived in Germany and have the ability to do it legally.
350Z/370Z Tech Moderator
MY350Z.COM
MY350Z.COM
Now, if someone showed me a wind tunnel test that proved that removal of both dropped my cd by .01, I might consider it... Laff....
Not dissin', just sayin'... I be clueless or sumpin'....