Notices
Intake Exhaust Moving all that air in and out efficiently

Help Anyone? =/

Thread Tools
 
Search this Thread
 
Old 02-01-2013, 07:27 PM
  #1  
RedLine_ZR
Registered User
Thread Starter
iTrader: (2)
 
RedLine_ZR's Avatar
 
Join Date: Oct 2012
Location: Puerto Rico
Posts: 323
Likes: 0
Received 7 Likes on 4 Posts
Default Help Anyone? =/

Ok so yesterday I installed my Jwt pop charger.. I disconnected the battery did the change and connected the battery back up.. This morning it started up fine and went to get a haircut (~15min drive) after I was done I noticed the car started and almost turned off... Rpms went low but came back up to normal.. When I got home I turned it off and back on but it turned off by itself.. I then tried turning it on the and gave it a little gas and it stayed normal.. Any help or ideas as to how to fix the problem?

04 roadster stock besides the Jwt pop charger now


**cold starts its fine just when I start while hot it will do this

Last edited by RedLine_ZR; 02-01-2013 at 07:59 PM.
Old 02-01-2013, 07:35 PM
  #2  
Bmurray350z
New Member
iTrader: (34)
 
Bmurray350z's Avatar
 
Join Date: May 2011
Location: Burlington, NC
Posts: 8,069
Likes: 0
Received 91 Likes on 47 Posts
Default

make sure the hose that connects to the back of the intake pipe is all the way one. check the maf also.
Old 02-01-2013, 07:46 PM
  #3  
RedLine_ZR
Registered User
Thread Starter
iTrader: (2)
 
RedLine_ZR's Avatar
 
Join Date: Oct 2012
Location: Puerto Rico
Posts: 323
Likes: 0
Received 7 Likes on 4 Posts
Default

I checked it earlier to see if everything was tight seemed fine.. Might double check again in the am but abt checking the MAF. Do you mean check that it's plugged in right which it is.. If not then what else?
Old 02-01-2013, 08:21 PM
  #4  
freddys 350z
Registered User
 
freddys 350z's Avatar
 
Join Date: May 2011
Location: schertz, tx
Posts: 774
Likes: 0
Received 2 Likes on 2 Posts
Default

the small hose that connects to the bottom side of the intake pipe.
Old 02-01-2013, 08:21 PM
  #5  
myork
New Member
iTrader: (5)
 
myork's Avatar
 
Join Date: Mar 2009
Location: NJ
Posts: 541
Received 9 Likes on 7 Posts
Default

That is normal as the ECU is learning to adjust to the extra air. Give it a few days and it will stop.
Old 02-01-2013, 09:59 PM
  #6  
amr_electron
Registered User
iTrader: (8)
 
amr_electron's Avatar
 
Join Date: Nov 2009
Location: On Earth
Posts: 337
Received 13 Likes on 11 Posts
Default

I remember mine did the same thing after installing an Injen intake, Doing a reset took care of the problem.

Reset procedure,
Old 02-01-2013, 10:03 PM
  #7  
Z_on_TE37's
New Member
iTrader: (3)
 
Z_on_TE37's's Avatar
 
Join Date: May 2012
Location: Ohio
Posts: 436
Likes: 0
Received 0 Likes on 0 Posts
Default

Just google official ecu reset for 350z. Follow all 3 procedures, then it'll run perfect.




All times are GMT -8. The time now is 07:16 PM.