Brake disc removal problems
The following 3 users liked this post by travlee:
#22
New Member
iTrader: (6)
![Default](https://my350z.com/forum/images/icons/icon1.gif)
Not sure how a gear puller is going to help when it's the bolts on the studs that can't be undone. If they were loosened and the spacer was still stuck on then maybe. But the basic idiocy of this scenario seems to be the bolt/nuts.
I'm actually surprised the nuts haven't stripped/rounded throughout this affair.
I'm actually surprised the nuts haven't stripped/rounded throughout this affair.
#23
New Member
Join Date: Nov 2017
Location: Santa clarita
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://my350z.com/forum/images/icons/icon1.gif)
I had the exactly same problem when upgrading to brembos past week. The soolution that i found was to use a small torch to heat up the bolt/nut and the using a nut remover hammering with a rubber mallet.
https://www.harborfreight.com/electr...CABEgLGaPD_BwE
https://www.harborfreight.com/electr...CABEgLGaPD_BwE
The following users liked this post:
CFAUVEL (10-19-2019)
#25
350Z/370Z Tech Moderator
MY350Z.COM
MY350Z.COM
![](https://my350z.com/forum/images/ranks/premier.gif)
![](https://my350z.com/forum/images/ranks/moderator.gif)
Thread
Thread Starter
Forum
Replies
Last Post