Rookie mistake
#1
New Member
Thread Starter
Rookie mistake
Major rookie mistake. Replacing valve covers and didn’t label order wiring harness plugs into each coil pack. Have photo of which plug goes to cylinder 6 but 2 & 4 exit the harness at nearly same location and can’t really tell which goes to which. I believe I have #6 correct, but 2 & 4 tougher to figure out. Can anyone tell me if my markups on photo are correct?
#2
New Member
Let me see if I a picture for you. By the way, I thought I had mine in the wrong order because it was idling really rough like a diesel. Turns out I had a forgotten to plug in a vacuum hose on the passenger side into the plenum. Also, a plenum leak around the gasket will cause it as well. Sounds crazy, but if you put some saran wrap around the seam it will seal it up if there is a leak and will make it easy to find. Listen for some hissing.
#3
New Member
Here you go.. I had this same issue and luckily I found a video on you tube and was able to capture a frame of the "before" to figure it out.
Last edited by Jim Stephens; 04-05-2021 at 04:59 AM.
The following users liked this post:
Stico (04-05-2021)
The following users liked this post:
Jim Stephens (04-05-2021)
Thread
Thread Starter
Forum
Replies
Last Post
LNVFX
2003-2009 Nissan 350Z
11
04-30-2019 08:25 PM