I recently replaced my flywheel, clutch and pressure plate on my 2008 nissan 350z and when i was putting everything back i cannot find what goes in this connector. These two connections are located right next to the starter, i could be completely dumb and overlooking it. Any help would

be greatly appreciated.

 

I honestly don't recall, it looks like a two-wire plug, so perhaps passenger front ABS sensor? You seriously don't have a hanging plug tucked away somewhere? Perhaps the HRs are different, but when I did a clutch job on my DE, the majority of the harness connections I had to move were for the transmission.
-Icer

 

I dont have any wires hangin off tht i can see, it is a 2 wire plug. Yea the only ones i had to remove was the ones wrapped around the trans. Idk maybe it doesnt have anything but for the life of me i cant figure it out lol

 

Just a guess, but I think the only other connections around that area are for the back-up lamp switch and the PNP switch.

 

Both of those are connected, these 2 connectors are up by the front of the trans where the starter hooks up

 

Idk if this will help any but here is a shot from the back of the trans lookin towards the front. The 2 connectors are right in front of the slave if tht helps any

 

So that's the driver's side then? Unless this is a JDM model. Again HRs may have done things different here, but the starter should be on the passenger side. I recall the crank position sensor being in that area, other than that, there's the O2 sensors.
-Icers

 

It is not a jdm model (although i wish) it is on the drivers side, all the o2 sensors are plugged in, ill double check but im pretty sure the crank sensor is also

 

My first thought was crank position sensor but there's no mention of the car not running or not running well which would certainly be the case if the cable was detached.

 

Yea the car runs fine, no issues tht i can tell immediately