LED Taillight install -- pics
#1
Thread Starter
Finally some go
iTrader: (5)
Joined: Jun 2006
Posts: 6,940
Likes: 3
From: Santa Barbara, CA
LED Taillight install -- pics
This install is about as easy as you can get. But I would still take my time with it.
It's pretty straight foward ... pop the blacks caps covering the bolts off using a 10mm wrench set to unscrew the three bolts.
When removing the old brake housings, pull from the skinny end first and slowly work your way down towards the wider end (trust me on this, you don't want to start from the wider end).
There's two plugs you have to disconnect (one for each bulb). Pinch the little arrows and ease the plugs out. You only have to use the the bigger plug for the new LEDs (smaller one is not needed, make sure you tuck it away so it won't obstruct the back of the housing)
The bigger plug goes into the only available outlet on the back of the new LED brake light housing.
Once again install the LED lights skinny end first and work you way down until you hear them pop into place. Screw the three bolts back on and pop on the caps and BAM you're done.
It's pretty straight foward ... pop the blacks caps covering the bolts off using a 10mm wrench set to unscrew the three bolts.
When removing the old brake housings, pull from the skinny end first and slowly work your way down towards the wider end (trust me on this, you don't want to start from the wider end).
There's two plugs you have to disconnect (one for each bulb). Pinch the little arrows and ease the plugs out. You only have to use the the bigger plug for the new LEDs (smaller one is not needed, make sure you tuck it away so it won't obstruct the back of the housing)
The bigger plug goes into the only available outlet on the back of the new LED brake light housing.
Once again install the LED lights skinny end first and work you way down until you hear them pop into place. Screw the three bolts back on and pop on the caps and BAM you're done.
Last edited by dutchboy350Z; 09-25-2006 at 01:06 PM.
#6
Sponsor
Performance Nissan
Performance Nissan
iTrader: (92)
Joined: Dec 2004
Posts: 6,151
Likes: 0
From: Pasadena/Bay Area
Originally Posted by zand02max
My next mod along with a Nismo exhaust, great pics!
https://www.mynismo.com/products/?id=2779
#7
Thread Starter
Finally some go
iTrader: (5)
Joined: Jun 2006
Posts: 6,940
Likes: 3
From: Santa Barbara, CA
I'll add that going through Performance Nissan was very convenient and hassle-free. I ordered the LEDs on the 12th through UPS regular ground and they arrived on the 20th (not bad considering I'm in Northern Virginia and they're in Duarte, CA ). They came in a huge box with padding galore and then in two invididual boxes with more bubble wrap. Needless to say they were in perfect condition.
Trending Topics
#9
Originally Posted by Andy@Performance
#12
Thread Starter
Finally some go
iTrader: (5)
Joined: Jun 2006
Posts: 6,940
Likes: 3
From: Santa Barbara, CA
Originally Posted by solidsnake
Arent they about 350 bucks. I think its worth it. They are a HUGE difference in the exterior styling. Car looking good!