I can't find any information on the stock impedance of the 6 1/2" door speakers.

I want to put Bass Blockers in for all 4 speakers in the front (tweets and mains), and need to know the impedance so I can order the right ones.

I think VandyZ has done this, but I could be wrong. I know it's a temporary solution to a permanent problem (bad stock speakers), but help on this is welcomed.

BTW - my Custom Subwoofer Enclosure plans for the factory location are progressing. I'm into the final 3D modeling and actual placement of drawings on a plan sheet. Then the build notes, and I'll release it.

Thanks again for the help with the Bass Blockers.

 

... I'm dying here...


...Anybody?...


...Bueller?...Bueller?


...bumpity-bump.

 

I only put bass blockers (caps) on the tweets. I can help you figure out what caps to buy if you need.

 

Give me a sec and I will go measure the impedance of the fronts

 

Damn, already tossed them. I think they were 4 or 6 ohm.

 

This may to a big assumption, but the rear's were rated at 32 ohm (no ********) The front's may be the same. Not sure, I left them at the install shop and havn't looked back yet....Pieces of crap (but at least I didn't blow the extra $$$ on the Blose up(yeah right!!!)grade...

 

32 is correct. That is what mine had on speaker. ..and what he said.

 

backs were 32 ohm so that the sound stage is towards the front, way towards the front!

 

FRONTs are 4 ohms 40 watts max
REARs are 32 ohms at 40 waats max

got these from DiverDown's pics at https://my350z.com/forum/showthread....threadid=17445

good luck!

 

Thanks!