This is my first headunit install. my buddy always installed them for me before. The only 2 wires i have left are one that says Car speed signal input and another that says reverse gear signal input. Where should i hook these wires to. Also another long light green wire that says to connect it to the parking brak power supply.

 

need to know what you are installing.
are you using a wire harness adapter?

 

its a AVIC-D2 and yes i have the wirine harness adapters that plug into the factory wiring.

 

Sounds like the wires for the Nav feature. Your speed wire is located in the harness found behind white box below your headunit. I think most people tap the reverse wire, on the side quarter panel behind seat on drivers side. I remember reading several threads on connecting these two wires. If I had time to located them for you, I would, but I am at work. I am sure you tried to search for them,,,but try searching under speed pulse wire,,,,and reverse signal wire. I hope you find something to help,,,good luck and keep us posted.

 

yea i searched but it was late. im goin to try again today. thx

 

is www.avic411.com down. it wont load for me at home?

 

Do what I would do when I build something and have screws left over...
shrug and figure I didn't needed it any way [

 

Well i know i need the reverse wire so and the vss wire. I need to know where to connect the light green wire to the parking brake power supply.