n1sm0r

iTrader: (3)

Hey

I have a non-bose stereo, and I'm in the process of adding my amp and subwoofer. I want to keep the stock stereo just for simplicity sake, but I just need some tips on installing the line output converter so I can use a speaker signal to communicate with my amp.

What do you stereoguys recommend? I was hoping to get the signal from the rear speakers so I can put the output converter closer to my amp (less wiring, easier to hide wires etc). What wires should I splice into?

Just to clarify, this amp will only power my subwoofer, not the rear speakers, but I need to get my signal for my output converter from the rear speakers

Any ideas?

Input greatly appeciated

w8lifter21

iTrader: (1)

Easier to pull the radio and and grab them from back there, unless you're replacing the rear speakers. Yes your sub amp will only power the sub.

w8lifter21

iTrader: (1)

audio:

Radio 12v
yellow
+
radio harness


Radio Ground (chassis)
Radio Ignition lt. green + radio harness
Radio Illumination red/blue + radio harness
Factory Amp Turn-on green/yellow + radio harness
Power Antenna green/white + radio harness
LF Speaker +/- blue/red - black/white +,- radio harness
RF Speaker +/- yellow/red - red/white +,- radio harness
LR Speaker +/- lt. green/red - black/yellow +,- radio harness
RR Speaker +/- blue/orange - black/pink +,- radio harness

all wiring guide courtesy of DEI

n1sm0r

iTrader: (3)

thanks dude! appreciate it. I was advised to wire in my output converter in parallel rather than in series, so I'll just be slicing the wires at the speaker terminals.