Subwoofer time... rounding out the new system
01-15-2008 | 01:24 PM
#21
Registered User
Joined: Jul 2007
Posts: 519
Likes: 0
From: Corpus Christi, TX
^^^ Preach on brotha'!
Unfortunately, save for about a half dozen regulars around here that I don't need to name, the science is wasted. All most of the posters around here want is... *boom*.
And they mostly all want a Z-Enclosures box, two JL's and a JL amp. At least it's simple. Heh.
Unfortunately, save for about a half dozen regulars around here that I don't need to name, the science is wasted. All most of the posters around here want is... *boom*.
And they mostly all want a Z-Enclosures box, two JL's and a JL amp. At least it's simple. Heh.
01-15-2008 | 02:54 PM
#22
Originally Posted by Paul350Z
The Diamond has a Qtc of 0.625 in the volume of box you installed it in ... the box and speaker combined create the Qtc. That's a very good match actually with .7 considered "perfect" - at least perfectly flattest. At 0.625 you've lost a tiny bit of gain for a tiny bit of deeper response but likely not very noticeable and I have no doubt a very tight/deep sounding system likely better than most.
Originally Posted by Paul350Z
The OP did a pretty good job of describing his bass preference and therefore I recommended putting his ears on a speaker that's going to have a bit higher Qtc - at least that's a good place to start. 
bass response in a house music environment! Daggers...
Thread
Thread Starter
Forum
Replies
Last Post
Justin100
Intake Exhaust
26
11-29-2015 03:58 PM
