stein

iTrader: (3)

I need a + and - wire in the rear license plate area that is on when the ignition is on. I am clueless to where these are located. Can someone direct me to these, I really don't want to gut the interior to get to the fuse box, thanks

stein

iTrader: (3)

Ok, I found the fuse 10A down by the kick panel and have run the wire (black and red) to this location. Here is where I am lost. I don't know where to plug the red in or the black. I also have a grey wire that is suppose to go to the brake but directions don't say to which wire on the brake like, just says no splicing.

Help would be great hookong this up.

Thanks

adamtaylorpcb

iTrader: (7)

or use the wires from the light back there

stein

iTrader: (3)

I need power even when the lights are not on. From what I have read in the J/B located to the lower left of the driver. I can use No. 1 fuse which will supply power to it when the ignition is in the start or on position. That would be power but where do I ground it to? Back where the luggage lamp is grounded I suppose.

I suck when it comes to elec stuff, speaker stuff as well.

stein

iTrader: (3)

I just realize this is in the wrong section

adamtaylorpcb

iTrader: (7)

why would you want it on when the lights arnt on, you wont be able to see it

stein

iTrader: (3)

uh, wrong! LEDs are damn bright! LEDs are blue and you can pretty much make out what is says from across the street in the middle of the day.