I apologize if this has been asked before, but I can't find it anywhere, and I apologize if this is in the wrong section. On to the question;

I have 60MM STRi Gauges (Boost, Oil Temp, Oil Press) that I am going to put in the location of the oem Digital Display, Oil Press, and Voltmeter, now my question is, can I tap into the wiring harness from the 3 factory gauges for lights, power, etc? Or am I going to have to run completely seperate wires?

Thanks in advance,
Craig.

 

There is one plug that controls all of these gauges, so you'd have to look at the service manual and get the pinouts to tap into the correct wires for illumination and power. IMO, running all new wiring is the way to go.